Uniden BCD396XT - Manual (Page 138)

Friday, November 07, 2008 138
Direct Access
Use this feature to quickly access a channel with number tags. System or channel number tags can be set
in the menu. However if you set a channel number tag that already exists in the same system, or if you set
a system tag that already exists in another system (include scan systems, service search with scan systems,
custom search with scan systems, CC Hits with scan systems), a warning message will be displayed “No.Tag
Exists Accept? (Y/N)”. Press [E / yes / gps] to set the same number tag, or press [. / no / pri] to input a new
number tag.
To jump to a tagged channel from HOLD mode, enter the system number tag followed by a decimal point
then the channel’s number tag, then press [MENU]. The scanner goes to Scan Hold Mode at the entered
number tag.
For example, if you want to select Channel E from the below example, press [7][.][5][Menu].
System A (Number tag = 1)
Channel A (Number tag = 1)
Channel B (Number tag = 5)
Channel C (Number tag = 100)
System B (Number tag = 7)
Channel D (Number tag = 10)
Channel E (Number tag = 5)
Channel F (Number tag = 3)
System number tag
Channel number tag
You do not have to enter the system number tag to select a channel in the current system.
When the scanner is holding on one of System A’s channels, press [1][0][0][Menu] to select Channel C.
If you press only system number tag with a dot, the scanner select the first channel of the system. Pressing
[7][.][Menu], Channel D is selected. If no such system number tag exits, the scanner displays “SYS Number
Tag XXX. is not Stored Press Any Key” and sounds an error tone.
If you enter an illegal channel number tag, the scanner displays “CH Number Tag XXX.XXX is not Stored
Press Any Key” and sounds an error tone.
Di rect Entry
7. 5