Uniden BCD396XT - Manual (Page 159)

Friday, November 07, 2008 159
Monitoring Close Call Transmission:
While monitoring a Close Call transmission, the scanner displays "Close Call" on the first line and the
frequency on the second line. The modulation is displayed and the Close Call icon blinks.
If Attenuation, Broadcast Screen or Repeater Find for Srch/CloCall Opt are on, each icon is displayed.
For example, if the scanner finds a transmission on 462.7125 MHz, it displays as follows.
In this condition, the scanner does not check for other Close Call hits.
Press [Hold / ] while monitoring a Close Call hit to go to Close Call Hold.
Turn [Scroll Control] to cancel the monitoring condition. Then the scanner checks the remaining CC Bands.
If it gets a Close Call hit, the scanner alerts again. Otherwise, it returns to the previous mode.
Press [L/O] once to temporarily lock out the frequency. The scanner displays "Temporary L/O".
Press [L/O] twice in a second to permanently lock out the frequency. The scanner displays “Locked Out”
then resumes searching from the next frequency.
The scanner stays on the frequency until the Delay time expires even if the transmission ends. Then the
scanner checks the remaining CC Bands. If it gets a Close Call hit, the scanner alerts again. Otherwise, it
returns to the previous mode.
If all the bands are set to Off at Set CC Bands, the scanner does not check for Close Call hits.The scanner
displays “Close Call” and "All Band Off!" and sounds an Error Tone when it tries to perform the Close Call
check. Then the scanner sets CC Mode to Off of Set CC Mode.
The scanner stays at this state.
In this state, press any key to turn all Close Call bands on.
Close Call
462. 7125MHz
NFM ATT
SCR REP
Close Call
All Band Off!