Uniden BCD396XT - Manual (Page 190)

190
SRCH : This icon appears while in Search Mode.
MAX : This icon appears while in MAX Hold Search Mode.
This shows in the same place as " SRCH ".
HOLD : This icon appears while in Hold Mode.
This shows in the same place as " SRCH ".
MF 850. 8125 : This icon and number show the marker frequency.
: This icon shows the signal level.
: This icon shows the marker point.
: This icon shows the center frequency point.
START 850. 00 : This icon and number shows the start frequency of the search range.
END 852. 00 : This icon and number shows the end frequency of the search range.
CF 851. 0000 : This icon and number shows the center frequency.
SPN 2M : This icon and parameter shows the frequency span.
STP 12. 5K : This icon and parameter shows the search step.
NFM : This icon shows the modulation type.
ATT : This icon appears when the attenuator state for a range is On.
I FX : This icon appears on the frequency has IF exchange On.
Search Mode
The scanner searches and displays the signals of the frequency range in real time.
The scanner displays "SRCH".
The frequency range expressed in 32 bars is determined by the center frequency and span.
If the frequency range includes outside of the range from 25.0000 to 1300.0000 MHz, the scanner does
not search that range.
While searching, the center frequency icon and the bar which shows the current frequency blink.
The scanner starts from the lowest frequency of the frequency range and searches in ascending order.
If the scanner finds a transmission, the scanner displays a signal level (0-7) in the bar including the
frequency.
If the scanner finds some signals in the bar, the strongest and the latest signal are displayed.
Note: If a signal is outside of band coverage, the scanner doesn't search it.
Press [FUNC] + [Scan / srch] in Max Hold Search Mode to go to this mode.
Max Hold Search Mode
The scanner searches the signals of the frequency range.
The scanner displays the frequency for the strongest signal.
The scanner displays "MAX".
The other functions are the same as Search Mode.
Press [FUNC] + [Scan / srch] in Search Mode to go to this mode.