Uniden BCD396XT - Manual (Page 247)

247
<COMMAND TIN>
Get/Set TGID Info
Controller → Radio
TIN,[INDEX][\r]
TIN,[INDEX],[NAME],[TGID],[LOUT],[PRI],[ALT],[ALTL],[RSV],[AUDIO_TYPE],
[NUMBER_TAG],[ ALT_COLOR],[ALT_PATTERN],[VOL_OFFSET][\r]
Radio → Controller
TIN,[NAME],[TGID],[LOUT],[PRI],[ALT],[ALTL],[REV_INDEX],[FWD_INDEX],
[SYS_INDEX],[GRP_INDEX],[RSV],[AUDIO_TYPE], [NUMBER_TAG],[ ALT_COLOR],
[ALT_PATTERN],[VOL_OFFSET] [\r]
TIN,OK[\r]
[INDEX] : TGID Index
[NAME] : Name (max.16char)
[TGID] : TGID
[LOUT] : Lockout (0:Unlocked / 1:Lockout)
[PRI] : Priority (0:OFF / 1:ON)
[ALT] : Alert Tone (0:OFF / 1-9:Tone No)
[ALTL] : Alert Tone Level (0:AUTO/ 1-15)
[REV_INDEX] : Reverse TGID Index of the Group
[FWD_INDEX] : Forward TGID Index of the Group
[SYS_INDEX] : System Index of the TGID
[GRP_INDEX] : Group Index of the TGID
[AUDIO_TYPE] : Audio Type (0:All/1:Analog Only/2: Digital Only)
[NUMBER_TAG] : Number tag (0-999 / NONE)
[ALT_COLOR] : Alert Light color
(OFF,BLUE,RED,MAGENTA,GREEN,CYAN,YELLOW,WHITE)
[ALT_PATTERN] : Alert Light Pattern(0:ON / 1:SLow / 2:Fast)
[VOL_OFFSET] : Volume Offset (-3 - +3)
Get/Set TGID Information.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
When the system protect bit is ON, except [REV_INDEX], [FWD_INDEX],
[SYS_INDEX], [GRP_INDEX], other parameters will be send as a reserve
parameter in the Radio -> Controller command.
<COMMAND GLI>
Get Lockout TGID (for Rvw L/O ID)
Controller → Radio
GLI,[SYS_INDEX][\r]
Radio → Controller
GLI,[TGID][\r]
GLI,-1[\r]
: No more lockout TGID
This command is used to get L/O TGID list of a system.
You should call this command again and again to get all L/O TGID until the
scanner returns “-1”.
“-1” means that no more L/O TGID exists.
When the system protect bit is ON, only “-1” will be send in the Radio ->
Controller command.
This command is only acceptable in Programming Mode.