Notice of location data input, Error messages, Bad tgi d press any key – Uniden BCD396XT User Manual

Page 31

Advertising
background image

Friday, November 07, 2008

31

Hexadecimal TGID edit
Turn the [Scroll Control] to select Hexadecimal characters from “0” to “F”,

Press [4 / LEFT / ifx] to move the cursor left or press [6 / RIGHT / disp] to move cursor right.

Press [E / yes / gps] to set the Hex ID.

Note: You can change the TGID format in Set ID Format (DEC/HEX)

If you press the decimal key when there are already an acceptable number of hyphens, the TGID is cleared
and the editing cursor moves to the first position.

Note: For details of TGID formats, please see: TGID FORMAT FOR TRUNKED SYSTEM.

If the entered TGID is invalid, the scanner beeps an Error Tone and displays "Bad TGID".

Press any key to return to the editing mode.

Bad TGI D

Press Any Key

Notice of Location Data Input

Use WGS84 (World Geodetic System 1984) for latitude and longitude input.

The acceptable range of latitude and longitude is as follows.

Latitude

: 90º00'00.00 S - 00º00'00.00 N - 90º00'00.00 N

Longitude

: 180º00'00.00 E - 000º00'00.00 W - 180º00'00.00 W

The actual navigation distance may differ from the calculated one when a latitude exceeding 85 degrees
(either North or South) is used.

Error Messages

If the scanner tries to create a new System/Location/Site/Group/Channel/TGID when it is already at the
limit of System/Group/Channel, it displays “Over Limit”. (See: Memory Architecture)

If the scanner tries to create a new System/Location/Site/Group/Channel/TGID when the memory is full, it
displays “Memory Full”.

If the scanner tries to create a new System/Location/Site/Group/Channel/TGID when the memory is
broken, it displays “Memory Error”. When the scanner displays this message, you must initialize the

memory by pressing [2 / sr2] + [9 / mod] + [Hold /

] while turning on the scanner. The scanner has a

repair fault if this does not correct the problem.

Advertising