Cisco ASA 5505 User Manual

Page 105

Advertising
background image

2-5

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 2 Getting Started

Configuring ASDM Access for Appliances

Examples

The following configuration converts the firewall mode to transparent mode, configures the VLAN 1
interface and assigns it to BVI 1, enables a switchport, and enables ASDM for a management host:

firewall transparent

interface bvi 1

ip address 192.168.1.1 255.255.255.0

interface vlan 1

bridge-group 1

nameif inside

security-level 100

interface ethernet 0/1

switchport access vlan 1

no shutdown

dhcpd address 192.168.1.5-192.168.1.254 inside

dhcpd enable inside

http server enable

http 192.168.1.0 255.255.255.0 inside

Accessing ASDM Using a Non-Default Configuration (ASA 5510 and Higher)

If you do not have a factory default configuration, or want to change the firewall or context mode,
perform the following steps.

Prerequisites

Access the CLI according to the

“Accessing the Appliance Command-Line Interface” section on

page 2-1

.

Detailed Steps

Command

Purpose

Step 1

(Optional)

firewall transparent

Example:

hostname(config)# firewall transparent

Enables transparent firewall mode. This command clears your
configuration. See the

“Configuring the Firewall Mode” section

on page 4-1

for more information.

Step 2

interface management 0/0

ip address

ip_address mask

nameif name

security-level number

no shutdown

Example:

hostname(config)# interface management 0/0

hostname(config-if)# ip address

192.168.1.1 255.255.255.0

hostname(config-if)# nameif management

hostname(config-if)# security-level 100

hostname(config-if)# no shutdown

Configures the Management 0/0 interface. The security-level is a
number between 1 and 100, where 100 is the most secure.

Advertising