Cisco ASA 5505 - Manual (Page 1229)

58-9
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 58 Configuring the ASA IPS Module
Configuring the ASA IPS module
ASA 5510, ASA 5520, ASA 5540, ASA 5580, ASA 5585-X (Physical Module)
Connect to the ASA Management 0/0 interface and the IPS Management 1/0 interface.
What to Do Next
• (ASA 5510 and higher) Configure basic network settings. See the “(ASA 5510 and Higher)
Configuring Basic Network Settings” section on page 58-10 .
• (ASA 5505) Configure management interface settings. See the “(ASA 5505) Configuring Basic
Network Settings” section on page 58-11 .
Sessioning to the Module from the ASA
To access the IPS module CLI from the ASA, you can session from the ASA. For software modules, you
can either session to the module (using Telnet) or create a virtual console session. A console session
might be useful if the control plane is down and you cannot establish a Telnet session.
ASA 5585-X
Switch
PW R BO OT ALARM ACT VP N PS 1 HDD1 PS 0 HDD0 USB RESET 0 SFP1 SFP0 1 0 1 2 3 4 5 6 7 MGMT
0
1
AUX CONSOLE
PW R BO OT ALARM ACT VP N PS 1 HDD1 PS 0 HD D0 USB RESET 0 SFP1 SFP0 1 0 1 2 3 4 5 6 7 MGMT
0
1
AUX CONSOLE
PC (IP Address
from DHCP)
ASA Management 0/0
192.168.1.1
IPS Management 1/0
192.168.1.2
SSP
IPS SSP
331
182