Monitoring active/standby failover, Feature history for active/standby failover – Cisco ASA 5505 User Manual

Page 1324

Advertising
background image

62-18

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 62 Configuring Active/Standby Failover

Monitoring Active/Standby Failover

Monitoring Active/Standby Failover

Note

After a failover event you should either re-launch ASDM or switch to another device in the Devices pane
and then come back to the original ASA to continue monitoring the device. This action is necessary
because the monitoring connection does not become re-established when ASDM is disconnected from
and then reconnected to the device.

To monitor Active/Standby failover, enter one of the following commands:

For more information about the output of the monitoring commands, refer to the Cisco ASA 5500 Series
Command Reference
.

Feature History for Active/Standby Failover

Table 62-3

lists each feature change and the platform release in which it was implemented.

Command

Purpose

show failover

Displays information about the failover state of the unit.

show monitor-interface

Displays information about the monitored interface.

show running-config failover

Displays the failover commands in the running configuration.

Table 62-3

Feature History for Optional Active/Standby Failover Settings

Feature Name

Releases

Feature Information

This feature was introduced.

7.0

This feature was introduced.

IPv6 support for failover added.

8.2(2)

We modified the following commands: failover interface
ip
, show failover, ipv6 address, show monitor-interface.

Advertising