Monitoring active/active failover, Feature history for active/active failover – Cisco ASA 5505 User Manual

Page 1349

Advertising
background image

63-25

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 63 Configuring Active/Active Failover

Monitoring Active/Active Failover

Step 5

When you are finished, you can restore the unit or failover group to active status by enter the following
command on the unit where the failover group containing the interface connecting your hosts is active:

hostname(config)# failover active group group_id

Monitoring Active/Active Failover

To monitor Active/Active Failover, perform one of the following tasks. Commands are entered in the
system execution space unless otherwise noted.

For more information about the output of the monitoring commands, see the Cisco ASA 5500 Series
Command Reference
.

Feature History for Active/Active Failover

Table 63-3

lists each feature change and the platform release in which it was implemented.

Command

Purpose

show failover

Displays information about the failover state of
the unit.

show failover group

Displays information about the failover state of
the failover group. The information displayed is
similar to that of the show failover command but
limited to the specified group.

show monitor-interface

Displays information about the monitored
interface. Enter this command within a security
context.

show running-config failover

Displays the failover commands in the running
configuration.

Table 63-3

Feature History for Active/Active Failover

Feature Name

Releases

Feature Information

Active/Active failover

7.0

In an Active/Active failover configuration, both ASAs can
pass network traffic.

We introduced this feature and the relevant commands.

IPv6 Support in failover

8.2(2)

We modified the following commands: failover interface
ip
, show failover, ipv6 address, show monitor-interface.

Advertising