Configuring domain attributes for tunneling – Cisco ASA 5505 User Manual

Page 1477

Advertising
background image

67-51

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 67 Configuring Connection Profiles, Group Policies, and Users

Group Policies

Split tunneling network lists distinguish networks that require traffic to travel across the tunnel from
those that do not require tunneling. The ASA makes split tunneling decisions on the basis of a network
list, which is an ACL that consists of a list of addresses on the private network.

If you use extended ACLs, the source network determines the split-tunneling network. The destination
network is ignored. In addition, because any is not an actual IP address or network address, do not use
the term for the source in the ACL.

The value access-list name parameter identifies an access list that enumerates the networks to tunnel or
not tunnel.

The none keyword indicates that there is no network list for split tunneling; the ASA tunnels all traffic.
Specifying the none keyword sets a split tunneling network list with a null value, thereby disallowing
split tunneling. It also prevents inheriting a default split tunneling network list from a default or specified
group policy.

To delete a network list, enter the no form of this command. To delete all split tunneling network lists,
enter the no split-tunnel-network-list command without arguments. This command deletes all
configured network lists, including a null list if you created one by entering the none keyword.

When there are no split tunneling network lists, users inherit any network lists that exist in the default
or specified group policy. To prevent users from inheriting such network lists, enter the
split-tunnel-network-list none command.

The following example shows how to set a network list called FirstList for the group policy named
FirstGroup:

hostname(config)# group-policy FirstGroup attributes

hostname(config-group-policy)# split-tunnel-network-list FirstList

Configuring Domain Attributes for Tunneling

You can specify a default domain name for tunneled packets or a list of domains to be resolved through
the split tunnel. The following sections describe how to set these domains.

Defining a Default Domain Name for Tunneled Packets

The ASA passes the default domain name to the IPsec client to append to DNS queries that omit the
domain field. When there are no default domain names, users inherit the default domain name in the
default group policy. To specify the default domain name for users of the group policy, enter the
default-domain command in group-policy configuration mode. To delete a domain name, enter the no
form of this command.

hostname(config-group-policy)# default-domain {value domain-name | none}

hostname(config-group-policy)# no default-domain [domain-name]

The value domain-name parameter identifies the default domain name for the group. To specify that
there is no default domain name, enter the none keyword. This command sets a default domain name
with a null value, which disallows a default domain name and prevents inheriting a default domain name
from a default or specified group policy.

To delete all default domain names, enter the no default-domain command without arguments. This
command deletes all configured default domain names, including a null list if you created one by
entering the default-domain command with the none keyword. The no form allows inheriting a domain
name.

The following example shows how to set a default domain name of FirstDomain for the group policy
named FirstGroup:

Advertising