Cisco ASA 5505 - Manual (Page 460)

23-4
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 23 Defining Route Maps
Defining a Route Map
Defining a Route Map
You must define a route map when specifying which of the routes from the specified routing protocol
are allowed to be redistributed into the target routing process.
To define a route map, enter the following command:
Customizing a Route Map
This section describes how to customize the route map and includes the following topics:
• Defining a Route to Match a Specific Destination Address, page 23-4
• Configuring the Metric Values for a Route Action, page 23-5
Defining a Route to Match a Specific Destination Address
To define a route to match a specified destination address, perform the following steps:
Detailed Steps
Command Purpose
route-map name {permit | deny}
[sequence_number]
Example:
hostname(config)# route-map name {permit}
[12]
Creates the route map entry. Enters route-map configuration mode.
Route map entries are read in order. You can identify the order using the
sequence_number argument, or the ASA uses the order in which you add
route map entries.
Command Purpose
Step 1 route-map name {permit | deny}
[sequence_number]
Example:
hostname(config)# route-map name {permit}
[12]
Creates the route map entry. Enters route-map configuration
mode.
Route map entries are read in order. You can identify the order
using the sequence_number option, or the ASA uses the order in
which you add route map entries.
Step 2 Enter one of the following match commands to match routes to a specified destination address:
match ip address acl_id [acl_id] [...]
[prefix-list]
Example:
hostname(config-route-map)# match ip
address acl_id [acl_id] [...]
[prefix-list]
Matches any routes that have a destination network that matches
a standard ACL or prefix list.
If you specify more than one ACL, then the route can match any
of the ACLs.