Default settings, Configuring network object nat – Cisco ASA 5505 User Manual
Page 585
30-3
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 30 Configuring Network Object NAT
Default Settings
•
If you change the NAT configuration, and you do not want to wait for existing translations to time
out before the new NAT configuration is used, you can clear the translation table using the clear
xlate command. However, clearing the translation table disconnects all current connections that use
translations.
Note
If you remove a dynamic NAT or PAT rule, and then add a new rule with mapped addresses
that overlap the addresses in the removed rule, then the new rule will not be used until all
connections associated with the removed rule time out or are cleared using the clear xlate
command. This safeguard ensures that the same address is not assigned to multiple hosts.
•
Objects and object groups used in NAT cannot be undefined; they must include IP addresses.
•
You can use the same mapped object or group in multiple NAT rules.
•
The mapped IP address pool cannot include:
–
The mapped interface IP address. If you specify any interface for the rule, then all interface IP
addresses are disallowed. For interface PAT (routed mode only), use the interface keyword
instead of the IP address.
–
(Transparent mode) The management IP address.
–
(Dynamic NAT) The standby interface IP address when VPN is enabled.
–
Existing VPN pool addresses.
•
For application inspection limitations with NAT or PAT, see the
Chapter 42, “Getting Started with Application Layer Protocol Inspection.”
Default Settings
•
(Routed mode) The default real and mapped interface is Any, which applies the rule to all interfaces.
•
(8.3(1), 8.3(2), and 8.4(1)) The default behavior for identity NAT has proxy ARP disabled. You
cannot configure this setting. (8.4(2) and later) The default behavior for identity NAT has proxy
ARP enabled, matching other static NAT rules. You can disable proxy ARP if desired. See the
“Routing NAT Packets” section on page 29-21
for more information.
•
If you specify an optional interface, then the ASA uses the NAT configuration to determine the
egress interface. (8.3(1) through 8.4(1)) The only exception is for identity NAT, which always uses
a route lookup, regardless of the NAT configuration. (8.4(2) and later) For identity NAT, the default
behavior is to use the NAT configuration, but you have the option to always use a route lookup
instead. See the
“Routing NAT Packets” section on page 29-21
for more information.
Configuring Network Object NAT
This section describes how to configure network object NAT and includes the following topics:
•
Configuring Dynamic NAT, page 30-4
•
Configuring Dynamic PAT (Hide), page 30-6
•
Configuring Static NAT or Static NAT-with-Port-Translation, page 30-10
•