Cisco ASA 5505 - Manual (Page 758)

37-18
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 37 Configuring Management Access
Configuring AAA for System Administrators
• Configure enable authentication (see the “Configuring Authentication to Access Privileged EXEC
Mode (the enable Command)” section on page 37-19 ).
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
IPv6 Guidelines
Supports IPv6.
Default Settings
By default, the following commands are assigned to privilege level 0. All other commands are assigned
to privilege level 15.
• show checksum
• show curpriv
• enable
• help
• show history
• login
• logout
• pager
• show pager
• clear pager
• quit
• show version
If you move any configure mode commands to a lower level than 15, be sure to move the configure
command to that level as well, otherwise, the user will not be able to enter configuration mode.
To view all privilege levels, see the “Viewing Local Command Privilege Levels” section on page 37-26 .