Cisco ASA 5505 - Manual (Page 880)

43-4
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 43 Configuring Inspection of Basic Internet Protocols
DNS Inspection
Configuring DNS Rewrite with Two NAT Zones
To implement a DNS Rewrite scenario similar to the one shown in Figure 43-1 , perform the following
steps:
Step 1 Create a static translation for the web server using the dns option. See Chapter 30, “Configuring
Network Object NAT.”
Step 2 Create an access list that permits traffic to the port that the web server listens to for HTTP requests.
hostname(config)# access-list acl-name extended permit tcp any host mapped-address eq port
where the arguments are as follows:
acl-name—The name you give the access list.
mapped-address—The translated IP address of the web server.
port—The TCP port that the web server listens to for HTTP requests.
Step 3 Apply the access list created in Step 2 to the mapped interface. To do so, use the access-group command,
as follows:
hostname(config)# access-group acl-name in interface mapped_ifc
Step 4 If DNS inspection is disabled or if you want to change the maximum DNS packet length, configure DNS
inspection. DNS application inspection is enabled by default with a maximum DNS packet length of 512
bytes. For configuration instructions, see the
“Configuring a DNS Inspection Policy Map for Additional
Inspection Control” section on page 43-7 .
Step 5 On the public DNS server, add an A-record for the web server, such as:
domain-qualified-hostname. IN A mapped-address
where domain-qualified-hostname is the hostname with a domain suffix, as in server.example.com. The
period after the hostname is important. mapped-address is the translated IP address of the web server.
The following example configures the ASA for the scenario shown in Figure 43-1 . It assumes DNS
inspection is already enabled.
hostname(config)# object network obj-192.168.100.1-01
hostname(config-network-object)# host 192.168.100.1
hostname(config-network-object)# nat (inside,outside) static 209.165.200.225 dns
hostname(config)# access-list 101 permit tcp any host 209.165.200.225 eq www
hostname(config)# access-group 101 in interface outside
This configuration requires the following A-record on the DNS server:
server.example.com. IN A 209.165.200.225
Overview of DNS Rewrite with Three NAT Zones
Figure 43-2 provides a more complex scenario to illustrate how DNS inspection allows NAT to operate
transparently with a DNS server with minimal configuration. For configuration instructions for scenarios
like this one, see the
“Configuring DNS Rewrite with Three NAT Zones” section on page 43-6 .