Ryobi SSP200 - Manual

how to get started
WARNING: This How To Get Started sheet is
not a substitute for reading the operator’s manual.
To reduce the risk of injury or property damage, user
must read and understand operator’s manual before
using this product.
Lubricate the piston.*
Fill sprayer with paint/stain.
Choose proper spray tip.
Use the 1 in. round fan tip for
latex paints and stains. This
tip sprays in a round pattern.
Use the 12 in. wide fan tip for
latex paints, oil-based paints,
and stains. This tip sprays in
a wide pattern that can be
adjusted from horizontal to
vertical.
Plug in the sprayer.
Spray on scrap material to prime.
Paint as desired, keeping the tip of the sprayer
12 inches away from the surface.
Unplug the sprayer.
Return unused paint or stain to original container
for short or long term storage.
Clean sprayer.
1
2
3
4
5
6
For detailed instructions on how to perform any of
the steps below, please see the operator’s manual.
988000-023
03-01-10 (REV:01)
7
8
2
3
4
9
6
7
8
5
9
1
*For best performance lubricate piston after every use.