Ryobi P635 - Manual

RWD
FWD
how to get started
WARNING: This How To Get Started sheet is
not a substitute for reading the operator’s manual.
To reduce the risk of injury or property damage, user
must read and understand operator’s manual before
using this product.
Lubricate the piston.
Fill backpack tank with paint.
Choose proper spray tip.
Install battery pack into backpack unit.
Connect the paint supply tube to the backpack and to the
paint sprayer*.
Connect the DC power cord of the sprayer into the outlet on
the backpack unit.
Place the backpack motor switch in the forward position.
Pull the switch trigger to spray paint.
Spray on scrap material to test.
Paint as desired, keeping the tip of the sprayer
8 to 10 inches away from the surface.
Disconnect DC power cord.
Place motor switch in reverse to return unused paint to tank.
Remove the battery pack.
Return unused paint to original container.
Clean backpack unit and sprayer.
1
2
3
4
5
6
For detailed instructions on how
to perform any of the steps below,
please see the operator’s manual.
987000-760
5-26-09 (REV:00)
7
8
D
3
6
5
9
Use the 1 in. round fan tip for
latex paints, oil-based paints,
and stains.
Use the 12 in. wide fan tip for
latex paints.
*For set-up when using the paint roller,
please see the operator’s manual.
10
A
B
C
D
E
1
4 C
7 A
9 10 8
B
2
E
CLEANING