Altera Multiaxis Motor Control Board User Manual

Multiaxis motor control board, Features

Advertising
background image

February 2014

Altera Corporation

MNL-1073

Reference Manual

© 2014 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS,

QUARTUS and STRATIX words and logos are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark

Office and in other countries. All other words and logos identified as trademarks or service marks are the property of their

respective holders as described at

www.altera.com/common/legal.html

. Altera warrants performance of its semiconductor

products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any

products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use

of any information, product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are

advised to obtain the latest version of device specifications before relying on any published information and before placing orders

for products or services.

101 Innovation Drive
San Jose, CA 95134

www.altera.com

Feedback Subscribe

ISO

9001:2008

Registered

Multiaxis Motor Control Board

This reference manual describes the Altera

®

Multiaxis Motor Control Board.

Efficient control of torque and speed of AC motors requires corresponding control of
voltage and frequency that you supply to the motor. Typically, you filter the AC input
voltage for electromagnetic interference (EMI), correct it to achieve unity power
factor, then rectify it to yield a DC voltage. You then invert the rectifier output again
through switching of power electronics, such as insulated-gate bipolar transistors
(IGBTs) to create the appropriate variable AC voltages and frequency for the motor.
Control algorithms such as Field Oriented Control (FOC) of PMSMs require you to
measure and analog to digitally A/D convert motor current and voltages, to provide
the required feedback to the controller. In addition, you use analog-to-digital
converters (ADCs ) to monitor the DC link voltage and current. Multiaxis drives
achieve either a high degree of coordination of control across motors or, in some
applications, integrate control of multiple independent motors to reduce overall
system cost. In closed-loop control systems, modern drive requirements continue to
evolve the need for higher precision position and velocity encoder feedback devices.
Standard encoder interfaces, 7such as EnDat, BiSS, and HiperFace, are based on
traditional sin and cosine encoder techniques. These encoder interfaces incorporate
communication controllers that can transmit information back to the drive digitally,
which enhances their performance in noisy environments. Encoder interfaces support
features, such as online inspection of motor parameters and line delay measurement,
which you can incorporate into the motor control algorithm.

The Multiaxis Motor Control Board contains all the power electronics, current and
voltage sensing, and connections for motor position feedback. You can use the motor
Control Board to develop a motor control system that supports permanent magnet
synchronous motors (PMSMs) or brushless DC (BLDC) motors. The Multiaxis Motor
Control Board is suitable for single-axis and multiaxis motor control applications and
supports multiple position feedback interfaces..

Features

The Multiaxis Motor Control Board has the following features:

Power factor correction (PFC) and EMI filter

DC link power supply of 400 V

Switch mode power supplies for logic

IGBT power stages

Sigma-delta ADCs for sensing voltages and currents

Brake (chopper) switch

Advertising