Qs464 – Q-See NETWORK DVR QS408 User Manual
Page 10
18
19
VGA
1
485A
485B
3
2
4
1
2
RJ45
DC +12V
IN
AUDIO IN
AUDIO OUT
VIDEO OUT
VIDEO IN
-
+
ON/OFF
1
2
4
7
6
8
10
9
3
5
Item #
Connector
Description
1
Power Switch
Power On/Off
2
AUDIO
OUTPUT
For connection to amplified speaker
3
VIDEO IN
Video input for connecting analog video signal input (BNC)
4
AUDIO IN
Audio input for connecting audio signal (2 feeds)
5
NETWORK
For connecting Ethernet cable
6
DC 12V Power Connection
7
VIDEO OUT
Video output for connecting TV (BNC)
8
RS485
RS485 for connecting PTZ
9
USB
Mouse port
10
VGA OUTPUT
To connect to VGA monitor
Item #
Name/ Symbol
Description
1
STANDBY
Press to set the system in standby mode. Press again to wake.
2
CHANNEL/
NUMBERS/
PLAYBACK
Press buttons 1-4 to view that channel full-screen
Press buttons 1-0 to input passwords and user IDs.
DURING PLAYBACK PRESS:
◄ ◄
Increase reverse playback speed 1X, 2X, 4X.
n
/
►
Press to freeze playback to one frame, then press
again to advance frame-by-frame.
►
Press to start playback
► ►
|
Press to slow playback speed by 1/2, 1/4, 1/8.
► ►
Press to increase forward playback speed 1X, 2X,
4X.
3
MENU/EXIT
Press to open/close the main menu.
4
IR SENSOR
IR Receiver for remote control.
5
LED
INDICATORS
Shows recording status and motion detection (Alarm).
6
NAVIGATION
▲
Press to move cursor up; in PTZ mode, press to pan
camera up.
▼
Press to move cursor down; in PTZ mode, press to
pan camera down.
◄
Press to move cursor left; in PTZ mode, press to pan
camera left.
►
Press to move cursor right; in PTZ mode, press to
pan camera right.
7
OK
In menus, press to confirm selections; in PTZ mode, press to
change the navigation buttons to control a connected PTZ
camera (not included)
8
USB
The upper port is to connect a USB flash drive for
data backup and firmware upgrades.
The lower port is to connect a USB mouse.
QS464
1
2
3
4
5
6
7
8
9
0
MENU
EXIT
OK
2
1
4
8
6
3
5
7
REC ALARM
USB 2.0
USB MOUSE
QS464
FRONT PANEL
REAR PANEL