AVUE AV676PIRW – 1000 TVL Dome CCTV Camera with 2.8-12mm Lens and OSD User Manual
AVUE Video surveillance systems
AV676PIR - Black
AV676PIRW - White
Thank you for purchasing our product. Before attempting to connect
or operate this product, please read the instructions carefully before
use.
DESCRIPTION
AV676PIR(W) uses advanced imaging technology from
SONY IMX138 CMOS sensor to capture image resolution as
high as 720P@60FPS and outputs analog signal through
CVBS/BNC. It features 2D/3D adaptive noise reduction.
External button accesses camera’s OSD menu to set Motion
Detection, Privacy Zone, Digital Zoom, Digital Picture
Correction, Shutter, White Balance, and other imaging
features.
PRECAUTIONS
1.
Use appropriate power supply.
The power input for AV676PIR(W) is DC12V. Using wrong power source will
damage the camera permanently.
2.
Do not attempt to disassemble the camera.
There is not serviceable parts.
3.
Handle the camera with care.
Avoid abusing the camera by striking, shaking, or other improper
handling.
4.
Do not place the camera in the following locations:
a.
Where temperature is lower than -4 ℉ or higher than 131 ℉;
b.
Where humidity is higher than 90%.
5.
Clean the CMOS faceplate with care.
Do not use strong detergents. Use a piece of lens tissue or cotton tipped
applicator and ethanol.
6.
Do not attempt to aim the camera at the sun.
Aiming at the sun or other extremely bright objects causes smear to
appear irrespectively of whether the camera is operating or not. This can
damage the CMOS.
7.
Do not put the camera in places with interference.
When this camera is installed near the equipment like wireless
communication device that emits strong electromagnetic field, some
irregularities such as noise on the monitor screen may happen.
FEATURES
● Sony IMX138 720P CMOS Sensor
● CVBS/BNC 960H/720P@60FPS Video Output
● True Day & Night
● Motion Detection, Privacy Zones
● Adaptive 2D/3D Noise Reduction
● Ingress Protection Rated IP66: Dust & Weather Proof
● OSD Menu & External Button menu access
PARTS INSTRUCTIONS
1. Ring Enclosure
2. Camera Holder
3. Base
4. Camera Lens
5. Wire Out Hole
6. Four install screws holes (on base)
www.avueinc.com