CP Electronics VITMR-EBDSPIR-B - Manual

LOAD 8 Amp resistive and incandescent lighting
6 Amp fluorescent lighting
3 Amp compact fluorescent lighting
3 Amp low energy lighting
3 Amp low voltage lighting
(switch primary of transformer)
Fluorescent lighting
(max 6 fittings recommended)
For fluorescent lighting total power factor
correction capacitance must not exceed 40μF.
3 Amp fans and ventilation equipment
Switch SON lighting loads via a contactor
SUPPLY VOLTAGE 220-240 Volts AC 50 Hz
TIME OUT PERIOD Adjustable 10s to 30m
LIGHT LEVEL Light to dark
TERMINAL CAPACITY Sensor:2.5mm 2
Ceiling Rose:2.5mm 2
MATERIAL Flame retardant ABS
TYPE Class 2
TEMPERATURE -10°C to 35°C
CONFORMITY EMC-2004/108/EC
LVD-2006/95/EC
Part Numbers Specification
Detection Pattern
VITMR-EBDSPIR-B PIR presence detector
with ceiling rose
DBB Surface mounting
back-box
Ref #WD315 Issue 4
C.P. Electronics Ltd
Brent Crescent
London
NW10 7XR
United Kingdom
Tel:
+ 44 (0) 333 900 0671
Fax: + 44 (0) 333 900 0674
www.cpelectronics.co.uk
[email protected]
IMPORTANT NOTICE!
This device should be installed by a qualified electrician in
accordance with the latest edition of the IEE wiring regulations.
Due to our policy of continual product improvement CP Electronics reserves the right
to alter the specification of this product without prior notice.
VITMR-EBDSPIR-B PIR presence detector switches are designed to provide automatic control of light-
ing, heating or ventilation loads. They detect movement using a PIR sensor and turn the load on.
When an area is no longer occupied the load will switch off after an adjustable time out period. These
sensors are supplied pre-wired with a 3m lead and include a ceiling rose for ease of installation.
An adjustable internal light sensor provides additional energy saving in lighting applications. When an
area is occupied lighting is only switched on when the level of natural light is below a preset level.
When the unit is first powered up the PIR sensor will always detect immediately regardless of whether
the room is occupied.
Description and Operation
INTERNAL
DETECTOR WIRING
(for information only,
do not re-wire detector)
N
L
L/Out
PIR Presence Detector with Ceiling Rose
Product Guide
VITMR-EBDSPIR-B
LUMINAIRE
Live
CIRCUIT PROTECTION
(IF REQUIRED)
Screw fixings to
conduit box
Each pole has two screw terminals.
Each terminal accepts 1 x 2.5mm 2
Live supply
Earth
Neutral
Permanent
Live
CEILING ROSE WIRING