OT Systems ET1100CPp series - Manual

ET1100CPp Series
Industrial 10/100Base-TX Ethernet over Coaxial Converter with PoE+ & PoC
V1.3 1
This quick start guide describes how to install and use the 10/100Base-TX Ethernet Extender over Coax with High
Power over Ethernet (PoE+) & Power over Coax (PoC). The EoC converter introduced here consists of a
transmitter (TX) and receiver (RX) and provides one channel for Ethernet over a coaxial cable with PoC & PoE.
Overview
The ET1100CPp Series product provides Ethernet Extension of 1-CH 10/100Base-TX over Coaxial cable (1Km
max.). The products provide high power PoE (30W max Power Sourcing Equipment (PSE)) to the network camera.
The products support PoC, hence, no power point is required for the transmitter and the network camera at the
transmitter side. The product is good for retrofit of analogue system by using the existing cable infrastructure.
General
To ensure trouble free transportation and storage, all OT Systems products must be thoroughly inspected, tested and
properly packed before delivery. Check the product upon receipt for any visible damage which may have been
caused during shipment.
Package Content

Industrial 10/100Base-TX Ethernet over Coaxial Converter x 1

Quick Start Guide x 1
Hardware Description
Transmitter
ET1100CPp-T
Receiver
ET1100CPp-R