OT Systems ET1100C2 series - Manual

ET1100C2 Series
Industrial 10/100Base-TX Ethernet plus CVBS Over Coax Converter
1 V1.3
This quick start guide describes how to install and use the Industrial Coaxial Converter. This is the Coaxial Converter
of choice for harsh environments constrained by space.
Overview
ET1100C2 is a pair of 10/100Base-TX Ethernet plus CVBS (composite video baseband signal) over coax converters.
It completely complies with the international standards such as IEEE 802.3 10Base-T, IEEE802.3u 100Base-TX,
and IEEE 802.3X.
The product series consists of a transmitter (ET1100C2-T) and receiver (ET1100C2-R). The maximum transmission
distance of a coaxial cable is 300m. The ET1100C2 series products can transmit not only the existing CVBS over the
coaxial cable, but also the IP signals of network products (e.g. IP cameras) at the same time. With ET1100C2 series
products, it is a cost effective way to upgrade the analogue video surveillance system to workable with the IP
cameras to the video surveillance system without laying the cable again.
General
To ensure trouble free transportation and storage, all OT Systems products must be thoroughly inspected, tested
and properly packed before delivery. Check the product upon receipt for any visible damage which may have been
caused during shipment.
Package Content
 Transmitter (ET1100C2-T) or Receiver (ET1100C2-R) of Ethernet Extender over Coaxial Converter x1
 Power Adapter x 1

Quick Start Guide x 1
Physical Description
Front/Rear Panel
Power Input Coax Data SPD PWR
CVBS
Input / Output CVBS
In/Out
Link/ACT ACT LINK