Analog Way ASCENDER 16 (LIVECORE) - Ref. ASC1602 Quick Start Guide User Manual

Quick start guide, Ascender 16, Ref. asc1602

Advertising
background image

Ascender 16

- Ref. ASC1602

QUICK START GUIDE

Thank you for choosing

Analog Way

and the Ascender 16. By following these simple steps, you will be able

to set up and use your Powerful multi-screen Seamless Switcher based on

Analog Way

’s LiveCore™ platform

within minutes. Discover the Ascender 16 capabilities and intuitive interface while commanding top-notch

presentations and unleash your creativity for a new experience in show and event management.

• 1 x Ascender 16 (ASC1602)

• 1 x Power supply cord

• 1 x Ethernet cross cable (for device control)

• 1 x MCO 10 pin connector

• 1 x Web-based Remote Control Software included and hosted on the device

• 1 x Rack mount kit (the parts are stowed in the packaging foam)

• 1 x User manual (PDF version)*

• 1 x Quick start guide*

* User manual and quick start guide are also available on

www.analogway.com

WHAT’S IN THE BOX

QUICK INSTALL AND SETUP

Connecting with the Web RCS

The Ascender 16 uses standard ethernet LAN

networking. To connect the Web RCS to your new

Ascender 16, you first need to connect a computer

to the Ascender 16 using the Ethernet cable. Then

on your computer open an internet browser which

supports Flash® player.

Into this internet browser, please enter the IP

address of the Ascender 16 displaying on the front

panel screen.

The connection should start.

Often, computers are set to DHCP client (automatic

IP detection) mode. You may need to change the

IP address configuration on your computer before

you can connect. These settings are found in the

properties for your LAN network adaptor, and vary

by operating system.

The default IP address on the Ascender 16 is

192.168.2.140

with a netmask of 255.255.255.0

Therefore, you can assign your computer a static

IP address of 192.168.2.100 and a netmask of

255.255.255.0 and should be able to connect.

If the connection is not starting, please see:

• Be sure the computer IP address is on the same

network and subnet as the Ascender 16.

• Be sure that no two devices have the same IP

address (prevent IP conflicts)

• Check your network cable. You will need a

crossover ethernet cable if you are connecting

directly from the Ascender 16 to the computer. If

a hub or switch is involved, use straight ethernet

cables.

• For more information, please see the user manual

or contact Analog Way Technical Support.

Once you have successfully connected, the flash

app will automatically download and launch in your

browser. When the two icons in the bottom right

corner of the screen turn green, the Web RCS is

ready to use. If you are having trouble syncronizing,

try clearing the cache and refreshing the page

(ctrl+F5 in most browsers):

-

ASC1602:

will turn green when connected

-

Sync OK:

will turn green when the Web RCS has

finished syncronizing.

CAUTION!

The use of rear rack support

slide rails for all rack mounted

applications is highly recom-

mended. Damage caused by

improper rack mounting will not

be covered under warranty.

Go on our website to register your product(s)

and be notified about new firmware versions:

http://bit.ly/AW-Register

Advertising
This manual is related to the following products: