Artel DLC450 - Manual

Simplifying Media Transport ™
DigiLink
Media Transport Simplified
QUICK START GUIDE
HD-SDI Video-Over-IP Gateway
[DLC450]
• Mon HD-BNC - In TX mode, this BNC outputs a copy of the HD SDI signal
received on the BNC in connecter.
In RX mode , this BNC outputs a copy of the HD SDI signal sent out the
BNC out.
• RST Pushbutton - Pressing, holding in for more than 4 seconds and then
releasing this button will reset the module. Reset is similar to power-up
sequence of module. No user configuration data is changed during this
reset.
• Select Pushbutton - Not used, for future use.
DLC450 Front Panel:
1
4
3
2
1
4
3
2
1
4
3
2
5
MODULE SETTINGS Configuration
1 Operational Mode Set to either TX or RX depending on mode required
2 IP Address of Module IP address that Module uses to respond to Pings
3 Video Alarm ENABLE ALARM on loss of active video
4 SFP Alarm ENABLE ALARM on SFP not present
RECEIVER SETTINGS Configuration
1 Source IP
IP address that Module uses in unicast mode to receive
from
2 Multicast Group
Multicast IP Address that Module uses when in Multicast
Mode
3 Port
Port number setting must match the Port number
setting on the TX module that you wish to receive video
data from
4 Recovery Buffer
Specifies Data Latency Time from Ethernet in to SDI TX
out. Sm setting: latency is 100ms, Lg setting: delay is
120ms
TRANSMITTER SETTINGS Configuration
1 Video Source
Sets which input port for HD SDI video to In BNC or
available backplane inputs
2 Destination IP Address Destination Address which module is transmitting to
3 Port
Port number setting must match the Port number
setting on the RX module that you wish to transmit the
video data to
4 Time to Live Not applicable at this time
5 FEC Mode
Specifies Forward Error Correction (FEC) settings
• Specify Column or Row/Column or No FEC
• Specify FEC matrix (row and column) size (maximum
3000)