Dart seam, Basting – Baby Lock Crescendo (BLCR) Instruction and Reference Guide User Manual

Page 102

Advertising
background image

SEWING THE STITCHES

S-28

Basting

a

Select

and attach presser foot “J”.

b

Press the “Reverse Stitch” button to sew
reinforcement stitches, then continue
sewing.

c

Sew while keeping the fabric straight.

d

End the basting with reinforcement stitches.

Dart Seam

a

Select

and attach presser foot “J”.

b

Sew a reverse stitch at the beginning of the
dart and then sew from the wide end to the
other end without stretching the fabric.

*

If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at
the beginning of sewing.

a Basting

c

Cut the thread at the end leaving 50 mm
(approx. 1-15/16 inches), and then tie both
ends together.

*

Do not sew a reverse stitch at the end.

d

Insert the ends of the thread into the dart
with a hand sewing needle.

Memo

• When you use the basting stitch for

gathering, do not use a reinforcement stitch
at the beginning; you should lift the presser
foot, rotate the handwheel toward you
(counterclockwise), pull up the bobbin
thread and pull a length of top and bobbin
thread out from the rear of the machine.

• You can set the stitch length between 5 mm

(approx. 3/16 inch) and 30 mm (approx.
1-3/16 inches)

a Between 5 mm (approx. 3/16 inch) and 30 mm

(approx. 1-3/16 inches)

Advertising
This manual is related to the following products: