Baby Lock Crescendo (BLCR) Instruction and Reference Guide - Manual (Page 210)

UPGRADING YOUR MACHINE’S SOFTWARE
A-20
You can use USB media or a computer to upgrade software for your sewing machine.
When an upgrade program is available on “ www.babylock.com ”, please download the files following
the instructions on the website and steps below.
Upgrade Procedure Using USB
Media
a
While pressing the “Automatic Threading”
button, turn the main power to ON.
→ The following screen will appear on the LCD.
b
Press .
c
Insert the USB media into the USB port for
media/mouse on the machine. The media
device should only contain the upgrade file.
a USB port for media/mouse
b USB media
d
Press .
→ The upgrade file is loaded.
e
Remove the USB media, and turn the
machine off and on again.
UPGRADING YOUR MACHINE’S SOFTWARE
Note
• When using USB media to upgrade the software, check that no data other than the upgrade file is
saved on the USB media being used before starting to upgrade.
Note
• The access lamp will begin blinking after
inserting USB media, and it will take about 5
to 6 seconds to recognize the media. (Time
will differ depending on the USB media).
Note
• If an error occurs, a red text error message
will appear. When the installation is
performed successfully, following message
will appear.