Baby Lock Crescendo (BLCR) Instruction and Reference Guide - Manual (Page 48)

UPPER THREADING
B-46
Using the Twin Needle Mode
The twin needle can only be used for patterns that
show after being selected. Before you select a
stitch pattern, make sure the stitch can be sewn in
the twin needle mode (refer to the “STITCH
SETTING CHART” on page S-68).
a
Press and install the twin needle
(“CHANGING THE NEEDLE” on page B-51).
b
Thread the machine for the first needle
according to the procedure for threading a
single needle (“Upper Threading” on
page B-42).
c
Pass the thread through the needle bar
thread guides on the needle bar, then
thread the needle on the left side manually.
a Needle bar thread guide
d
Pull up the supplemental spool pin and set it
in the up position.
a Supplemental spool pin
CAUTION
• Twin needle (part code X59296-151) is
recommended for this machine. Contact your
authorized retailer for replacement needles
(size 2.0/11 is recommended).
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
• Do not sew with bent needles. The needle
could break and cause injury.
• When using the twin needle, it is
recommended to use presser foot “J”.
• When the twin needle is used, bunched
stitches may occur depending on the types of
fabric and thread that are used.
Use monogramming foot “N” for decorative
stitches.
• Before changing the needle or threading the
machine, be sure to press on the LCD
Screen, otherwise injuries may occur if the
“Start/Stop” button or any other button is
pressed and the machine starts sewing.
Note
• The “Automatic Threading” button cannot
be used. Manually thread the twin needle
from front to back. Using the “Automatic
Threading” button may result in damage to
the machine.