Baby Lock Crescendo (BLCR) Instruction and Reference Guide - Manual (Page 52)

CHANGING THE PRESSER FOOT
B-50
■ Attaching the Free Motion Echo
Quilting Foot “E”
a
Follow the steps in “Removing the Presser
Foot” in the previous page.
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
a Disc-shaped screwdriver
b Presser foot holder
c Presser foot holder screw
c
Remove the screw of the presser foot
completely from the presser foot shaft.
d
Set the adapter on the presser foot bar,
aligning the flat side of the adapter opening
with the flat side of the presser bar. Push it
up as far as possible, and then tighten the
screw securely with the screwdriver.
e
Attach the free motion echo quilting foot
“E” on the left side of the adapter with the
holes in the quilting foot and adapter
aligned.
f
Tighten the screw with the included
screwdriver.
CAUTION
• Be sure to securely tighten the screws with the
included screwdriver. Otherwise, the needle
may touch the quilting foot, causing it to bend
or break.