Baby Lock Sashiko 2 (BLQK2) Quick Reference Guide - Manual

Needle stops in the UP position. A space
and stitch will be formed when the foot
control is pressed (Blue LED is on).
Positioning
Button
Stitch
Formation
LED
Lights
Needle/Loading
Positions
Needle stops in the DOWN position
and the next stitch will be an actual
stitch (Green LED is on).
Needle stops in the DOWN position
and the next stitch will be a stitch
space (Orange LED is on).
Loading position
(press and hold the positioning button
for approximately 2 seconds, Yellow
LED is on).
1. Insert or remove the bobbin case
2. Replace latch wire
3. Replace needle
Bobbin winder is
engaged
(All LED lights are off) Bobbin winding completed
(Blue LED flashes on and off)
Warning
LED Lights
Orange LED light flashes on and off
1. Safety System is activated:
Side cover is open
Presser foot is raised
Latch wire is engaged in the release position
Foot control is pressed and presser foot is down when power is turned "ON"
2. Needle is in the down position and the presser foot is in the raised position.
3. Motor overload. When this occurs machine has to be turned off then turned back on
before using.
1. The Baby Lock Sashiko stitching will not unravel,so it is not necessary to make
tacking stitch.
2. Always stitch with fabric under the presser foot when machine is threaded.
3. Do not stitch over previous stitching or stitch down the same row of stitching.
4. Avoid stitching over pins.
5. Before removing bobbin case, changing needle, or replacing latch wire, place needle
in up position, remove fabric, and cut thread.
Important Notice