Besa Lighting 3-Light Round (12V Quick Connect Canopies) - Manual

FIXTURE INSTALLATION GUIDE
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
Model T23XQ/T23XL (Low Voltage Quick-Connect Canopy)
T23XQ-23XL, Rev.3 6-10
Caution: Turn off power to electrical box before installing
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
6. Restore power.
A
B
1. Carefully unpack parts. Remove existing Screws (C) from the Supply Box (A),
then secure the Mounting Bracket (B) to the Supply Box with same Screws.
Screws are provided if necessary.
2. To install the Canopy, connect the electrical leads
from the fixture to the house supply wires, black
to black and white to white, and secure with
wirenuts provided (E). Connect the house
supply ground to the bare copper canopy
ground, and secure with wirenut (F).
3. Align the circular opening of the Canopy with
the Threaded Nipple (D) on the Mounting
Bracket. Push the canopy up over the
Threaded Nipple until tight to ceiling,
then secure with the Decorative Cap Nut (G).
5. For assembly of the glass shade, please refer to the GLASS SHADE INSTALLATION GUIDE
that is included in with the pendant cord sets.
C
4. Place the Decorative Cap (H) over the threaded nipple on the canopy, then attach the
Besa Quick Connect Element (I). The Besa Quick Connect Element is furnished separately.
IMPORTANT: If using skyhooks with pendant elements, remember
to factor the additional cord length required prior to cutting cord.
G
D E
F
H
I
NOTE: Canopy shown is for
instructional purposes only, actual
canopy may vary in size.