Bronkhorst E-8000 User Manual
Instruction manual, E-8000 power supply readout and control system
Advertising
Doc. no.: 9.17.076E Date: 10-03-2015
Instruction Manual
Please read this Instruction Manual carefully before installing and operating the instrument.
Not following the guidelines could result in personal injury and/or damage to the equipment.
ATTENTION
E-8000
Power Supply
Readout and Control System
Advertising
Table of contents
Document Outline
- E-8000
- Table of contents
- 1 Scope of this manual
- 2 Starting up
- 3 User Interface
- 3.1 General operation
- 3.2 Settings menu
- 3.2.1 Readout settings screen
- 3.2.2 Readout format
- 3.2.3 Fluidset selection
- 3.2.4 Fluid capacity
- 3.2.5 Controller settings screen
- 3.2.6 Controller speed
- 3.2.7 Setpoint slope
- 3.2.8 Controller mode
- 3.2.9 Controller response settings
- 3.2.10 PID controller settings
- 3.2.11 Master slave settings
- 3.2.12 Counter settings screen
- 3.2.13 Set setpoint at counter limit
- 3.2.14 Set counter parameters
- 3.2.15 Set counter mode
- 3.2.16 Alarm settings screen
- 3.2.17 Set alarm mode
- 3.2.18 Set alarm mode parameters
- 3.2.19 Set setpoint at alarm
- 3.2.20 Setup menu
- 3.2.21 Get instrument information
- 3.2.22 Customize display info
- 3.2.23 Change usertag
- 3.2.24 Display appearance
- 3.2.25 Bus settings
- 3.2.26 Instrument node address
- 3.2.27 Operator node addresses
- 3.3 Advanced settings
- 3.4 Security settings
- 4 Modules
- 5 Troubleshooting
- 6 Removal and return instructions
- 7 Service