Cobra VLX 600 - Manual

23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016
www.cobrausa.com
03/07
* Cobra recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
Items Supplied >
1 - Sissy Bar w/pad
2 - Brackets
2 - Spacers, Short
2 - Spacers, Long
4 - M8 x 55mm Buttonhead Bolts
4 - M8 x 16mm Buttonhead Bolts
Application(s) >
HONDA VLX 600 1998 & UP
Instruction Manual >
Your sissy bar will install in just a few minutes using common tools. Read all instructions carefully and
completely before installing your new sissy bar.
1. Remove the stock fender rail bolts one side at a time.
2. Install the brackets on each side with one short supplied spacer at the front and one long supplied spacer at the
rear of each bracket between the bracket and the fender rail and secure using the four supplied (4) M8 x 55mm
Button Head bolts, do not tighten completely.
3. Install the sissy bar to the brackets using the four (4) supplied M8 x 16mm Button Head bolts then tighten all
hardware.
02-4601/02-5101/02-5601
DOCUMENT NO. 0019 REV. A
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016
www.cobrausa.com
03/07
* Cobra recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
Items Supplied >
1 - Sissy Bar w/pad
2 - Brackets
2 - Spacers, Short
2 - Spacers, Long
4 - M8 x 55mm Buttonhead Bolts
4 - M8 x 16mm Buttonhead Bolts
Application(s) >
HONDA VLX 600 1998 & UP
Instruction Manual >
Your sissy bar will install in just a few minutes using common tools. Read all instructions carefully and
completely before installing your new sissy bar.
1. Remove the stock fender rail bolts one side at a time.
2. Install the brackets on each side with one short supplied spacer at the front and one long supplied spacer at the
rear of each bracket between the bracket and the fender rail and secure using the four supplied (4) M8 x 55mm
Button Head bolts, do not tighten completely.
3. Install the sissy bar to the brackets using the four (4) supplied M8 x 16mm Button Head bolts then tighten all
hardware.
02-4601/02-5101/02-5601
DOCUMENT NO. 0019 REV. A