Code ECS-H Charger User Manual

Ecs-h battery handle charger, Quickstart guide

Advertising
background image

Quickstart Guide

ECS-H Battery Handle Charger

The ECS-H charger is designed to firmly and reliably hold
and charge wireless Code bar code readers equipped
with a battery handle.

Quickstart Guide

C007537_03_ECS-H_QuickStart Guide

C007537_03_ECS-H_QuickStart Guide

© Copyright. 2012 Code Corporation

ECS-H Battery Handle Charger

© Copyright. 2012. Code Corporation

Installation Instructions:

Included:

ECS-H Charger

Weighted Base
(If ordered)

Power Supply
(if ordered)

Screws
(If weighted base ordered)

Charging Instructions:

Firmly seat the battery handle in the charger. When the
charging clips are engaged, the LED will turn on.

Green LED indicates battery handle is fully charged.
Red LED indicates battery handle is charging.

Battery handles ship with approximately 50% battery life and
should be completely charged before initial use. Approximate time
to charge a depleted battery is 4 hours. Note: In certain reader
configurations, the LED on the charger may never turn green.

ECS-H with CR2500
and battery handle

The ECS-H charger is designed to firmly and reliably
hold and charge wireless Code bar code readers
equipped with a battery handle.

Installation Instructions:

Included:

ECS-H Charger

Weighted Base
(If ordered)

Power Supply
(if ordered)

Screws
(If weighted base ordered)

1. Plug the power supply into the charger and wrap the cable around

the post, as indicated in the diagram on the charger. Slide the cable
through the channel cut out. (Figures 1 and 2)

2. If a weighted base plate was ordered, place the ECS-H onto the

weighted base and secure with the screws provided (Figure 3). Plug
in power supply into the wall socket (or USB port if USB Charge
Cable ordered).

3. If a weighted base was not ordered, mount the charger to a surface

for added stability. Note: Because surface types differ, mounting
screws have not been included. Plug in power supply into the wall
socket.

Charging Instructions:

ECS-H with CR2500
and battery handle

Figure 1

Figure 2

Figure 3

1. Plug the power supply into the charger and wrap the cable around

the post, as indicated in the diagram on the charger. Slide the cable
through the channel cut out. (Figures 1 and 2)

2. If a weighted base plate was ordered, place the ECS-H onto the

weighted base and secure with the screws provided (Figure 3). Plug
in power supply into the wall socket (or USB port if USB Charge
Cable ordered).

3. If a weighted base was not ordered, mount the charger to a surface

for added stability. Note: Because surface types differ, mounting
screws have not been included. Plug in power supply into the wall
socket.

Figure 1

Figure 2

Figure 3

Firmly seat the battery handle in the charger. When the
charging clips are engaged, the LED will turn on.

Green LED indicates battery handle is fully charged.
Red LED indicates battery handle is charging.

Battery handles ship with approximately 50% battery life and
should be completely charged before initial use. Approximate time
to charge a depleted battery is 4 hours. Note: In certain reader
configurations, the LED on the charger may never turn green.

Advertising