Ethereal CS-HDC5EXTSR User Manual

Cs-hdc5extsr, Hdmi

Advertising
background image

CONNECTION DIAGRAM:

CONNECT AND OPERATE:

1. Connect a source such as a Blu-Ray Player, game console, A/V

Receiver, Cable or Satellite Receiver, etc. to the HDMI input on the

Transmitting unit.

2. Connect a display such as an HDTV or HD Projector to the HDMI output

on the Receiving unit.

3. Connect a single Category 5e/6 up to 164ft/50m to the output of the

Transmitting unit, and the other end to the input of the Receiving unit.

4. For power, plug both the Transmitting unit and Receiving unit with the

included power supplies.

5. Power on each device in the same sequence (receiver and transmitter

will already be powered when either unit is plugged in.)

At this point the display connected should display the source signal

connected to the extender set. If no signal is being displayed, check

the receiver EQ switcher (LOW for 0-20m cat6 cable, HIGH for 20-

50m cat6 cable). If a display is having difficulty receiving a signal,

please change the EDID setting or access the display’s menu and

adjust the resolution (lowest to highest until signal is displayed).
A 24 Hz vertical refresh rate may work better than 60 Hz or higher.

Use the source remote at the receiver emitter to test IR functionality.

If the IR remote function is not responding, check the emitters to

ensure they are placed correctly and are plugged into the correct IR

jacks on the Extender set receiving and transmitting units.
Wideband IR (20KHz---60KHz) instruction

IR BLASTER (TX)

To control the source: Plug IR Blaster into IR TX port of transmitter unit; place

blaster in front of the IR eye of the source. To control the display: Plug IR

Blaster into IR TX port of receiver unit; place blaster in front of the IR eye of

the display.

IR TARGET (RX)

To control the source: Plug IR Receiver into IR RX port of receiver unit; place

receiver at or near display. To control the display: Plug IR Receiver into IR

RX port of transmitter unit; place receiver in position where it is able to receive

remote signals.

HDMI

®

Extender

Single 50m/164ft UTP Cables

with Dual IR Control

CS-HDC5EXTSR

866-839-9187

460 Walker Street, Holly Hill, FL 32117

Advertising