Fire Magic 3287-1(P) Searing Station Built in - Manual

SAFETY WARNINGS & CODES
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
INSTALLATION AND OPERATING
INSTRUCTIONS
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OR USE.
DANGER
IF YOU SMELL GAS :
1. Shut off the gas to the appliance.
2. Extinguish any open fl ame.
3. Open lid if equipped.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or fi re department.
WARNING
1. Do not store or use gasoline or other
fl ammable vapors and liquids in the vicinity
of this or any other appliance.
2. A propane cylinder not connected for use
shall not be stored in the vicinity of this or
any other appliance.
Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746
CODE AND SUPPLY REQUIREMENTS: This
unit must be installed in accordance with local
codes and ordinances, or, in the absence of local
codes, with either the latest National Fuel Gas
Code (ANSI Z223.1/NFPA 54), or Natural Gas
and Propane Storage and Handling Installation
Code (CSA-B149.1).
This appliance and its individual shutoff valves
must be disconnected from the gas-supply piping
system when testing the system at pressures in
excess of
1/2 psig (3.5 kPa).
This appliance must be isolated from the gas-
supply piping system by closing its individual
manual shutoff valves during any pressure testing
of the gas-supply system at pressures up to and
including
1/2 psig (3.5 kPa).
All electrical outlets in the vicinity of the unit must
be properly grounded in accordance with local
codes, or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.1, whichever
is applicable.
Keep all electrical-supply cords and fuel-supply
hoses away from any heated surface.
WARNING
Improper installation, adjustment, alteration,
service, or maintenance can cause injury or
property damage. Refer to this manual. For
assistance or additional information, consult a
qualifi ed professional installer, service agency,
or the gas supplier.
Certifi ed to: ANSI Z21.58-2007
CSA 1.6-2007
09-41
1 L-C2-200 Rev 10 - 1401131145
SEARING STATION BUILT-IN
3287-1(P)