Fire Magic DC-WK-03 Island Enclosure Wheel Kit - Manual

REV 1 - 1504090745 L-C2-413 1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
This wheel kit is only for installation on Fire Magic
Island Enclosure models:
DC430-CBR-75SM
DC790-CBR-108SM
WHEN INSTALLING ON AN UNASSEMBLED
ISLAND ENCLOSURE
Prior to assembling the island enclosure, install the
wheel kit per the steps below.
1. Carefully place the left island wall upside down.
2. Align the left wheel assembly and fasten using
the included hardware and a 9 / 16 " open-end
wrench or equivalent (Fig. 1-2).
Note: The wheel assembly must stay level when
being installed.
3. Repeat for the right island wall using the right
wheel assembly as shown in Fig. 1-3.
Note: The wheel assembly must stay level when
being installed.
4. Follow your island instruction manual to
complete island installation.
Important: Before installing the countertop, use
the included hardware to properly
secure the wheel assemblies to the
front and rear walls.
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
ISLAND ENCLOSURE
WHEEL KIT
Model # DC-WK-03
Fig. 1-1 Overall install detail
Left side wall shown
(upside down)
(Exterior-side)
Fig. 1-2 Install left wheel assembly to bottom of left side wall
(Left wheel assembly) (Right wheel assembly)
(Keep level)
Fig. 1-3 Install right wheel assembly to bottom of right side wall
Right side wall shown
(upside down)
(Keep level)
(Exterior-side)