HiTi P520L - Manual (Page 18)

18
◎ Printer transportation
The following cautions are necessary in transportation of the printer. Since an
incorrect transportation method causes a printer fault, please follow the correct
method.
1. Remove the ribbon and paper from the printer before transporting the
printer. If the ribbon or paper cannot be removed due to a fault, consult with
the HiTi dealers or service center.
2. Do not switch off the power while the front cover is open. Close the front
cover while the power is ON and switch off the power when “Ribbon
Missing” is displayed on the LCD of the operation panel.
4.6 Loading ribbon instructions
Stretch the ribbon and load in right position.
＊
Attention: It is a mistake-proofing for users;
Please be sure the white head locates on white
indentation and black head locates on black
indentation.
4.7 Close front cover
When the ribbon and paper are finished
loading, please close the door to ensure printer
running properly. After each paper roll is
loaded, 4 sheets of paper will be cut without
printing automatically to ensure the paper
4.8 Loading scrap receptacle:
Clean it up periodically before full of scraps