Installation manual masterline extreme hybrid – HUBER+SUHNER MASTERLINE Extreme Hybrid User Manual
Page 3
HUBER+SUHNER disclaims any liability resulting from incorrect installation and use, including any damages resulting from the use of
tools and accessories other than the ones recommended herein. Any installation performed by unqualified personnel voids the product
warranty provided by HUBER+SUHNER. All due care and attention must be exercised when performing the installation of these pro-
ducts. For advice concerning the general handling of these products please contact HUBER+SUHNER.
Step 9
Do NOT use cable ties to secure FO or DC tail as these
may cause damage.
Comment: All connectors (fiber optic and power) are
protected with water proof (IP67) dust caps. Therefore
the MLE hybrid can be installed and left at the mast for later
installation of jumpers.
Step 10
Do NOT use cable ties to secure FO or DC tail as these
may cause damage.
Step 11
Remove protective cap from FO tail ready to connect
RRH Jumper.
•
Do NOT clean Q-ODC before connecting them
together. Q-ODCs are factory cleaned and verified to
ensure optimal performance. Cleaning during installation
potentially decreases performance.
Step 12
Connect FO jumper to FO tails by aligning keyway and
secure by pushing to latch mechanism.
Step 13
Connect power jumper to Power tail by aligning keyways
and secure using integral retaining nut.
Step 14
Connect FO and DC tails with RRH jumper.
INSTALLATION MANUAL
MASTERLINE Extreme Hybrid