Chapter 3, Installation, Installing the pd-01 – Delta PROFIBUS-DP Module for VFD Series Drives PD-01 User Manual

Page 10: Chapter 3 installation

Advertising
background image

PD-01 PROFIBUS-DP Module

DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED

7

Chapter 3 Installation

IMPORTANT NOTE:
Prior to the installation or remove the PD-01 from network, make sure the power of VFD
series Drives is switched off (not-energized).

Installing the PD-01

Improper installation of the PD-01 will cost its life usage. Please follow the instructions to
install your PD-01 carefully.

DIN Rail Installation

PD-01 can be secured by mounting to DIN rail. There is a small retaining clip locates at
the bottom of PD-01, place the PD-01 onto the DIN rail and gently push up on the clip to
ensure the PD-01 is mounted to the DIN rail.

Direct Mounting

Please use the specified M4 screws to install the PD-01. Also please ensure to tighten
them properly.

Screw
Mounting

Hole

DIN RAIL

CLIP

Advertising