K-Patents DD-01 - Manual

INSTRUCTION MANUAL
FOR DD-01
DIGITAL DIVERT CONTROL SYSTEM VERSION 4.1.
WITH MAIN PROGRAM 8.5 OR HIGHER
WARNING
The process medium may be hot or otherwise hazardous. Precautions when removing the sensor from
the process line:
Make sure that the process line is not under pressure. Open a vent valve to the atmosphere. For a retractor/isolation valve the line pres-
sure should be within specifications.
For a prism wash system, close a hand valve for the wash medium and disable the wash valve. Loosen the clamp or flange bolts cau-
tiously, be prepared to tighten again. Be out of the way of any possible splash and ensure the possibility of escape.
Use shields and protective clothing adequate for the process medium. Do not rely on avoidance of contact with the process medium.
After removal of the sensor, it may be necessary to mount a blind flange for security reasons.
Document/Revision No. IMD 1/5 Effective: June 20, 2005
This product manual is delivered to the end-user with a K-Patents product. Information in this manual is
subject to change without notice. The latest manual version is freely available at http//www.kpatents.com/.
You can also contact [email protected].
THE PASSWORD FOR PR-01-S IS 7 8 4 5 1 2 IN PROGRAM VERSIONS 4.0 AND HIGHER.
K-PATENTS OY
Postal address:
P.O. Box 77
FIN-01511 Vantaa, Finland
Tel. + 358-9-825 6640
Fax +358-9-825 66461
E-mail: [email protected]
http://www.kpatents.com/
K-PATENTS OY
Street address:
Elannontie 5
FIN-01510 Vantaa, Finland
Tel. + 358-9-825 6640
Fax +358-9-825 66461
K-PATENTS,INC.
1804 Centre Point Circle,
Suite 106,
Naperville, IL 60563
Tel. 630-955 1545
Fax 630-955 1585
E-mail: [email protected]
http://www.kpatents.com/