LEI Electronics PLJOGBK - Manual (Page 10)

- 9 -
3. The Bluetooth Setup Assistant will open. Follow prompts to connect your headset.
a. Introduction screen ill appear. Click “Continue”.
b. Select “Headset” from options and click “Continue”.
c. Ensure Jogger headset is in Discoverable mode (press and hold MFB until led
is flashing red and blue alternatively).
d. Select the headset from the list of devices that appear and click “Continue”.
e. “Gather information…” screen will appear. Click “Continue” when operation is
complete.
f. “Enter a passkey” screen will appear. Enter “0000” if not already entered and
click “Continue”.
g. “Pairing with your Bluetooth headset” screen will appear. Once you see the
“Congratulations…” screen appear you can click “Quit” to exit the pairing
process.
4. You should now see the headset appear in the list of devices.
5. To enable the Headset, select the headset from the list and click the “Perform
tasks with the selected device” button and select “Use Headset”.
6. It may takes a few moments, but you will then see the status change to
“Connected”. Your headset is now ready to use.
Note: The headset buttons for controlling playback are not supported in Mac OS 10.5
but are supported in Mac OS 10.7.