Louroe Electronics RN-2 User Manual

Rn-2

Advertising
background image

Model RN-2 is a audio mixer for combining two
microphones or two speaker/microphones into one
audio zone. It is mounted between the two microphones
and the Louroe base station or other receiving
equipment. Contains an adjustment potentiometer for
microphone balance control. The RN-2 is powered by
the Louroe base station. If the base station is not used
and RN-2 is interfaced directly with other equipment
(VCR, etc.), then 12 Vdc power must be applied to
terminals A and C of either the input or output terminal
block of the RN-2.

NOTE: RN-2 is a mixer for combining two microphones or two speaker/microphones to

create a larger audio monitoring zone. Both microphones serve as one zone.
They are NOT on separate channels

WIRING REQUIREMENTS

Microphone Only:
Louroe Verifact A, B, C, D, D-V, E, K or L-DT

Speaker Microphones:
Louroe Model TLI, TLM, TLMC, TLO, TLSP

2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire

NOTE:

Unshielded cable is not

satisfactory for audio systems

WIRING REQUIREMENTS

West Penn 452 or equivalent

WIRING REQUIREMENTS

4 Conductor consisting of:

+

2 Conductor shielded, 20 gauge
with 22 gauge drain (microphone
connection)

+

2 Conductor unshielded, 18 gauge

(speaker connection)

All in the same jacket

West Penn 356 or equivalent

UR

T

E

C

D

A

I

F

N

U

T

N

H

A

E

M

RN-2

MICROPHONE AUDIO MIXER

INSTALLATION AND OPERATING INSTRUCTIONS

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: (818)994-6498 / FAX: (818)994-6458

/ www.louroe.com

[email protected]

®

®

Page 1 of 4

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406

TEL (818) 994-6498

FAX

994-6458

website: www.louroe.com e-mail: [email protected]

(818)

®

rn_2_inst_3/15

Advertising
Table of contents