Lumens Technology VC-A20P - Manual (Page 30)

English - 29
7.2.5 Setting - advanced image encoding setting
1. Name of current connected camera
2. IP Ratio: Set IP Ratio, from 1 to 60
3. Force I Frame:
Check this item to insert IDR frame into specified series flow and apply its setting. User’s setting will be
reserved and displayed in GUI interface
4. Encode Preset:
Auto: Select between speed and quality depending on the encoding method used (e.g. HIGH_SPEED
mode for refresh rate of 60 frames per second and HIGH_QUALITY mode for high image quality)
HIGH_SPEED: Refresh rate of 60 frames per second is available
HIGH_QUALITY: Higher image quality can be obtained
SVC: SVC opened encoding mode is applicable to RTSP series flow of 8601, 8602, 8603 and 8604
ports, different refresh rate for different ports. See remark
5. Preset Save
<Remark> SVC connection address: rtsp://VC IP Address:Port/h264
1. 60Frame : rtsp://VC IP Address:8557/h264, e.g.: rtsp://192.168.100.150: 8557/h264
2. 30Frame : rtsp://VC IP Address:8601/h264, e.g.: rtsp://192.168.100.150: 8601/h264
3. 15Frame : rtsp://VC IP Address:8602/h264, e.g.: rtsp://192.168.100.150: 8602/h264
4. 7Frame : rtsp://VC IP Address:8603/h264, e.g.: rtsp://192.168.100.150: 8603/h264
5. 3Frame : rtsp://VC IP Address:8604/h264, e.g.: rtsp://192.168.100.150: 8604/h264
7.2.6 Setting - camera
1. Name of current connected camera
2. Adjust camera brightness / contrast / saturation / sharpness, etc.
3. Preset Save
1
2
5
3
4
1
2
3