Denso BHT-400B-CE - Manual (Page 48)

2.3 Preparation
2.3.1 Setting-up 1: Loading the battery cartridge
Before the first use of the BHT, be sure to load the battery cartridge as shown below. The battery
cartridge is not loaded in the BHT when shipped from the factory.
Into the BHT body
(1) Turn the BHT upside down.
(2) Slide the release button in the direction shown below and remove the battery cartridge cover.
(3) Push the battery cartridge into the BHT.
(To remove it, first make sure that the BHT is turned off. Slide the release button, remove the battery
cartridge cover, and pull up the battery pull strap.)
(4) Set the battery cartridge cover back into place and slide the release button to the original position.
(5) Place the BHT on the CU-400 to charge the rechargeable battery cartridge. (Refer to Chapter 5.
Section 5.5 “Charging the Rechargeable Battery Cartridge(using the CU-400)”.)
Release button
Battery cartridge cover
Battery pull strap
Battery cartridge
Battery pull strap
28