OpenEye CM-P307 - Manual

High Resolution Outdoor
Dome Camera
Model no:
CM-P307
CM-P307R
Camera Installation & Configuration
Please carefully read these instructions before using this product.
Save this document for future use.
31361AA
23221 E Knox Ave
Liberty Lake, WA 99019
1.888.542.1103
www.openeye.net
Precaution
• Do not attempt to dismantle the camera module mounted
within the dome. There are no user serviceable parts in
the camera module. Refer servicing to a qualified profes-
sional.
• Handle the camera with care. Do not abuse the camera.
Avoid striking or shaking it. Improper handling and stor-
age could damage the camera.
• Do not operate the camera beyond its temperature or
power source rating. Refer to the environmental informa-
tion provided in this document.
Features
• 650 TV-Line Resolution
• Digital Noise Reduction
• 3-axis camera
• IP67-rated
• Digital Wide Dynamic Range
• True Day/Night
General Specifications
Model No. CM-P307 CM-P307R
Image Sensor 1/3” Sony CCD
IP Rating IP67
Type / Format NTSC
Wide Dynamic Range Yes, Digital WDR
Minimum Illumination 0.05 Lux @ 50 IRE;
0.01 Lux @ 30 IRE
0.05 Lux @ 50 IRE;
0.01 Lux @ 30 IRE;
0.00 Lux (IR LEDs on)
Day / Night True Day/Night
Resolution 650 TVL
Service Monitor Jack Yes
S/N Ratio >50dB
Focal Length 2.8 ~ 12 mm
Iris Control Auto-iris
Synchronization Internal
Video Output 1.0Vpp 75Ω BNC Unbalanced
White Balance ATW, Manual
Auto White Balance Range 2500K ~ 9500K
Backlight Compensation BLC, HLC, Off
Auto Gain Control Low, Mid, High, Off
Operating Temperature -49˚ ~ 122˚ F (-45˚ ~ 50˚C)
Heater Yes
Power Consumption 4.32W (24vAC)
2.16W (12vDC)
10.8W (24vAC)
5.4W (12vDC)
Rated Amperage 0.24A 0.45A
Input Voltage 12vDC / 24vAC
Weight 1.8 lbs (0.82 kg)
Dimensions Dome : ø5.925” (150.5 mm) x H: 5.3” (130.5 mm)
Housing / Dome Cover White / Clear
Dimensions
Box Contents
• Screws (x3)
• Washers (x3)
• Torx security tool
• Service monitor cable
Regulatory Compliance
Emissions FCC part 15, subpart B, Class A
CE: EN61000-6-4:2007
Immunity CE: EN60130-4:1995 + A1:1998 + A2:2003
FCC COMPLIANCE
This product has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. The product generates, uses, and can
radiate radio frequency energy, and, if not installed and used in accordance with
the manufacturer’s instruction manual, may cause harmful interference with radio
communications. Operation of this product in a residential area is likely to cause
harmful interference, in which case you will be required to correct the interference
at your own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a non-residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference with the radio or television reception, which can be deter-
mined by turning the equipment off and on, you are encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the antenna of the radio/television receiver.
2. Increase the separation between this equipment and the radio/television
receiver.
3. Plug the equipment into a different outlet so that the equipment and the
radio/television receiver are on different power mains branch circuits.
4. Consult the dealer or an experienced radio/television technician for
additional suggestions.