Orion System OE217-00 - Manual

Form: ORION-OE217-01-DigitalRoomSensor-1C.doc
Page 1 of 1
Description
The OE217 series of Touch Screen Digital Room Sensors
are used to sense Space Temperature only or Space
Temperature & Space Humidity. The OE217-00 model is
the Space Temperature Sensor only model and can be
used with the VCM-X Controller (OE332-23-VCMX) and
the VAV/Zone Controller (OE324-02). The OE217-01 is a
combination Space Temperature & Space Humidity
Sensor model and can only be used with the VCM-X
Controller.
Besides sensing Temperature & Humidity, the Digital
Room Sensors also provide these other useful features:
• User Friendly Graphical LCD Display with LED
Backlight
• Display the Current Space and Outdoor Air
Temperature
• Display the Current Space Humidity and Outdoor
Air Relative Humidity (OE217-01 Model Only)
• Display the current Zone Setpoint Temperature
• Equipped With Push Buttons for Changing the
Zone Setpoint Temperature
• Equipped With an Override Button for Forcing the
VAV/Zone Controller or VCM-X Controller into
Occupied Operation from Unoccupied Operation
• Provides graphics to indicate the mode of operation
• Provides LEDs to indicate Schedule Override,
Button Push, and Alarms
Both sensors connect to the controllers using TSDRSC
modular cables of multiple lengths connected between the
controller and the sensor. The TSDRSC modular cables
should not run in conduit with other AC line voltage wiring
or with any conductors carrying highly inductive loads.
Mounting
The Digital Room Sensor is designed to be mounted to a vertical, 2” x 4” electrical box recessed in the wall. If the wall
cannot be penetrated, a plastic surface mount box such as those made by Wiremold
TM , may be used to mount the
sensor to the wall surface. The Sensor is mounted by removing the front cover and fastening the housing base to the
electrical box using the supplied (2) 6/32” x 1” machine screws. The Modular cable is then plugged into the phone jack
located on the circuit board that is mounted on the cover. The cover is then placed onto the housing base and the Allen
Screw on the bottom of the base is adjusted to hold the cover in place.
Technical Data OE217-00 & OE217-01 Digital Room Sensor
Sensor Element Type III Thermistor 10k ohm
@ 77
F Digital Sensing Device
Display 112 x 64 Monochrome Graphical LCD
w/LED Backlight
Sensor Reading
Range 40
F to 120F
RH = 0-100%
Connection RJ-45 Modular Female Jack
Ambient
Temperature
Limits -40
F to 180F Weight 3.2 oz.
Accuracy RH +/-2%, Temp +/- .5
F
Three Year Warranty WattMaster reserves the right to change specifications without notice
OE217-00 & OE217-01
Digital Room Sensors