Pacific Cycles REACH Rear Suspension maintenance - Manual

Reach Rear Suspension Maintenance Manual
Steps：
1
Use two 32mm open wrench to loosen the
hexagonal bolts in opposite direction (right
side in the photo). Be
careful not to scratch or
damage the surface.
2
Use 13mm deep socket to loosen the nut
inside.
3
Remove the nut, stainless steel washer,
aluminum washer and PU washer (shown
from right to left).
4
Remove the anodized tube.
5
Remove the nut and washer at the end of the
suspension.
6
Use 2mm allen key to remove the stop screws at
top and bottom.
7
Push the axle and PU unit out from left side.
8
Replace the PU or take the PU out and apply
grease.