Radionic G22WH-CP-CO - Manual

G Series
LED Undercabinet Light Fixture
For G22WH-CP-CO Radionic Hi-Tech Inc.
1 For complete warranty terms see www.Radionic.net/Warranty
Safety Precautions
Read all safety precautions and installation instructions
carefully before installing or servicing this fixture. Failure to
comply with these instructions could result in potentially fatal
electric shock and/or property damage.
This fixture must be wired in accordance with all national and
local electrical codes.
Do not handle any energized fixture or attempt to energize a
fixture with wet hands or while standing on a wet or damp
surface or in water.
FOR Model G22WH-CP-CO
Caution: - Injury to persons and damage to the fixture and/or
mounting surface or property may result if the fixture is pulled
from the surface. To reduce the likelihood of such injury or
damage, mount only on a surface that is mechanically sound.
Caution: Make sure power is off at fuse or circuit breaker
box. Check power wires for damage or scrapes.
Warning: Do not install over a heat source. Do not install
directly over water such as: fish tanks, sinks, laundry tubs etc.
This fixture is U.L. listed for indoor DRY applications only.
DO NOT PLUG IN MORE THAN
9Amps. load into the Convenience Outlet.
ASSEMBLY INSTRUCTIONS
1. Prepare fixture
Disconnect electrical power and turn off circuit
breaker before installing or servicing any part of this
fixture.
2. Mounting the fixture
A. Select a suitable sturdy dry mounting location (for
indoor applications only).
B. Secure the fixture using captive mounting screws
(provided) or toggle bolts (not provided) for hollow
mounting applications. Position the fixture in location
for mounting. Drill holes in the marked locations. Make sure that the fixture is very secure.
3. Plug –In Installation
A. Fixture must be mounted within 55” of an outlet, using only the included 5’ power cord.
B. Power can now be restored
4. Direct Wire
This fixture may not be direct or hardwired. Only use 5 foot cord supplied with the fixture.