Sea Eagle PaddleSki Swivel Seat Kit - Manual

Assembly Instructions for
PaddleSki Swivel Seat Kit
Parts for the PaddleSki Swivel
Seat Kit include:
A) Swivel Seat
B) 1 Long Aluminum Yoke
C) 1 Short Aluminum Yoke
D) 1 Aluminum Board
E) 1 Quick Release Seat
Mount for the Swivel Seat
F) 2 Rod Holders with Flush
Mount Adapters
Hardware for the PaddleSki
Swivel Seat Kit includes:
a) 4 black knurled nuts
b) 4 large washers
c) 4 large bolts
d) 4 small bolts with washers
& wing nuts
e) 8 half inch screws
Attach the flush mount
adapters for the rod holders at
each end of the long yoke in
the predrilled large hole.
Use the half inch screws to
attach the adapters to the
yoke with a philips head
screwdriver as shown.
Place the swivel seat mount in
the center of the aluminum
board and attach it using the
four small bolts, washers &
wing nuts. The aluminum
board has 4 predrilled holes in
the center for this.
Make sure that the wing nuts
are tightened properly by
hand.
Place the aluminum board
over the long yoke and attach
it using 2 long bolts, 2 large
washers & 2 black knurled
nuts as shown. The bolts
should be inserted from under
the aluminum yoke so that the
knurled nuts are on top.
Attach the small yoke at the
other and of the aluminum
board as shown using 2 long
bolts, 2 large washers & 2
black knurled nuts.
Unscrew the knurled nuts on
the center yoke of the
PaddleSki and remove the
upper aluminum yoke. Place
the assembled frame of the
swivel seat kit on the
PaddleSki.
Bolt the smaller yoke of the
frame in place of the upper
yoke that was removed to
secure it to the PaddleSki. The
longer yoke simply rests on
the pontoon towards the stern.
Place rod holders in the
adapters at both ends of the
long yoke.
Finally slide the swivel seat
into the quick release seat
mount installed on the
aluminum board and make
sure that the spring loaded
lever mechanism locks in
place.
The PaddleSki Swivel Seat Kit
is now ready for you
to go fishing.
a
c
b
d
e
A
B
C
D
E
F