SP Controls SmartBox+ Installation - Manual

9/13/200 SP Controls, Inc.
SmartBox Mounting Page 1 of 5
(877) 367-8444
S
DOCUMENTATION
Use the provided tempate to determine the location of the mounting bolts. We
have provided mounting bolts for sheetrock (the KAP toggles), wood (the LAG
bolts), and masonry (the expansion bolts).
The enclosed Smart Box is fully assembled. Remove the VCR/DVD cover with the
star-point security bit provided. Remove the facia (where the SmartPanel is
installed) by pulling the top towards you. It is held by clips at the top and hinges at
the bottom. Slide the spring hinge pins towards the center. Remove the side
panels by unscrewing the (5) 4-40 screws on each (one is on the bottom of the
unit).
Mount the box to the wall. Install the VCR/DVD player and place the (2) brackets
on the threaded rods. Use the (4) flange nuts provided to tighten the brackets onto
the top of the VCR/DVD.
Route the wires from the VCR/DVD up the sides using the split tubing. Power
should go up one side, video and audio up the other. Use the cable ties and
bases to secure the tubing so that there is a sufficient service loop for the box to
close and open without pinching or straining the cables.
Re-install the VCR/DVD cover, the right and left sides. Re-Install the facia after
you have installed the Smart Panel in it.
If you are using a SP3-AFVP+, it can be mounted to the studs inside the top of the
enclosure with the 4-40 nuts attached to this documentation.
If you have questions, please call us at 877 367 8444 and we would be happy to
walk you through the installation process.